URC-6250bc1 acting strange

[jackching]

Ok so i am programming this remote with upgrades from this website. I can get the STB and AUX device modes working fine the way i want them. When i try to add the TV device mode using my roku upgrade it seems to not work correctly. When i assign TV device discretes to certain buttons, the remote will automatically change from the TV mode to STB mode when those buttons are pressed. It's like it punches through to STB. I was having the same issue when i tried to setup the irc600 remote which makes me think it's me doing it wrong. When i want to start over from scratch, is the 9-8-1 command good enough or should i be erasing using rmir somehow? Anyone know what might be causing this? Forgot to mention that learned signals work fine on those buttons in TV device mode It just wont let me set macros using learned signals for some reason.

[jeffreydixon]

Ok so i am programming this remote with upgrades from this website. I can get the STB and AUX device modes working fine the way i want them. When i try to add the TV device mode using my roku upgrade it seems to not work correctly. When i assign TV device discretes to certain buttons, the remote will automatically change from the TV mode to STB mode when those buttons are pressed. It's like it punches through to STB. I was having the same issue when i tried to setup the irc600 remote which makes me think it's me doing it wrong. When i want to start over from scratch, is the 9-8-1 command good enough or should i be erasing using rmir somehow? Anyone know what might be causing this? Forgot to mention that learned signals work fine on those buttons in TV device mode It just wont let me set macros using learned signals for some reason. geometry dash lite

My URC-6250bc1 also has the same issue. Did you find the solution?

[The Robman]

Hi Jeffrey, explain in your own words what's happening with your remote.