HK AVR-247 / URC-8910 issues

fiveliter8 · Post by **fiveliter8** » Sun Feb 01, 2009 5:31 am

IR FILE:
https://www.hifi-remote.com/forums/dload ... le_id=6198
KM FILE:
https://www.hifi-remote.com/forums/dload ... le_id=6197

Originally, I tried to learn all of the codes from the original remote into the 8910 and they all were successful. It showed the protocol in IR as NEC1, device 128, sub device 112. I used KM to try and build my own upgrade, and when I loaded it onto the remote, none of the functions operated the receiver. I found this upgrade:
https://www.hifi-remote.com/forums/dload ... ile_id=415

which has a "HK combo" protocol, which I tried in the remote, and it controlled many functions but not all. The EFC's that I learned matched the functions and EFC's in the upgrade, so I modified the upgrade a little to suit my needs. All is well now EXCEPT when I have RCVR selected, hitting the chan up/down keys (mapped to tuner up/down) the remote resets (all characters in LCD screen come on and then go out). I've looked through my macros in IR, looked through the upgrade in KM, and can't figure out what is going on with those keys. Hoping someone might spot something I'm overlooking. Thanks!
Alex

Post by **vickyg2003** » Sun Feb 01, 2009 5:48 am

fiveliter8, you have some keymoves setup on Channel+,Channel- in Rcvr mode. They are pointing at a setup code of 0158. I would think that this upgrade code doesn't exist, causing your remote to Reset.

fiveliter8 · Post by **fiveliter8** » Sun Feb 01, 2009 6:26 am

Ahhhhhh, that was for my old receiver (sony). Knew I was overlooking something! Muchas Gracias!

Alex