Need advice on how to fix DIY JP1.2/3 cable

speaker.guy · Post by **speaker.guy** » Sat Sep 27, 2008 1:27 pm

The vacuum cleaner ate my trusty DIY JP1.2/3 cable today. The 9 pin and circuit board are intact, cable separated from soldered connections. 6 pin destroyed by the vacuum cleaner. How can I rebuild this?

prelude · Post by **prelude** » Tue Oct 28, 2008 5:09 am

speaker.guy wrote:The vacuum cleaner ate my trusty DIY JP1.2/3 cable today. The 9 pin and circuit board are intact, cable separated from soldered connections. 6 pin destroyed by the vacuum cleaner. How can I rebuild this?

hi, please open a ticket at http://www.csbooth.com and attach a pic, we can help you.

thanks

prelude · Post by **prelude** » Tue Oct 28, 2008 3:12 pm

prelude wrote:
speaker.guy wrote:The vacuum cleaner ate my trusty DIY JP1.2/3 cable today. The 9 pin and circuit board are intact, cable separated from soldered connections. 6 pin destroyed by the vacuum cleaner. How can I rebuild this?
hi, please open a ticket at http://www.csbooth.com and attach a pic, we can help you.

thanks

read your PM. We can either send you a header and schematic, so you can fix it yourself, or send it back to us, we can send you a new one.

BTW, thanks for the understanding that we don't visit this site often, thus if you PM us, you may not get any response in a timely fashion... but if you open tickets at www.csbooth.com, we will reply you quickly. because that is the correct way to get support form us.

Thanks