#value! error when choosing RCU810 and SAT

dick99999 · Post by **dick99999** » Sun Sep 10, 2006 12:05 am

When trying to set up a new dev ugrade I get this error #value! in cell F8 of the setup sheet. It appears right after choosing the RCU810 remote and then dev type Sat. Is it KM v9 or my setup?

Mark Pierson · Post by **Mark Pierson** » Sun Sep 10, 2006 6:14 am

dick99999 wrote:Is it KM v9 or my setup?

It's a minor bug in KM. An updated version should be available later today.

dick99999 · Post by **dick99999** » Sun Sep 10, 2006 1:27 pm

Thanks very much Mark, I have downlooded KM v9.05 and can indeed load my old v8 upgrades defs again.

JP1 Remotes

#value! error when choosing RCU810 and SAT

#value! error when choosing RCU810 and SAT

Re: #value! error when choosing RCU810 and SAT