used with the 8060 Kameleon Extender
When I use any of the four macros #8 though #11, I have a problem
sending a number to my Projector
The sequence X_TV, M2, 1 is supposed to select the projector, and
send the number one to it. (M1 sets TV device #1, a Toshiba TV,
and M2 sets TV device #2, a Panasonic projector)
If I manually issue M2 to the TV device, and then run the Macro,
I get the correct result.
However, if I manually issue M1 to the TV device, and then run the macro,
the M2 command within seems not to work, and the number is sent to
the wrong TV device
Can anybody spot my stupid mistake?
