Can I change delay after press to 0.0?

hostage · Post by **hostage** » Wed Jan 13, 2016 3:46 pm

I started writing some longer macros and noticed the 0.3 delay can add up if you have many commands in the macro, can I reduce this holding a remote aimed for 2-3 seconds seems silly...

Post by **vickyg2003** » Wed Jan 13, 2016 4:00 pm

Hostage is talking about a Nevo.

The changes that can be made are dependent on the remote model.

pH7_jp1 · Post by **pH7_jp1** » Wed Jan 13, 2016 4:33 pm

You can change it to 0.1, but not to 0.0.

hostage · Post by **hostage** » Thu Jan 14, 2016 8:08 am

pH7_jp1 wrote:You can change it to 0.1, but not to 0.0.

I'll try it when I get home, though it seemed to keep switching back to .3 w/ a max of 10 seconds.

pH7_jp1 · Post by **pH7_jp1** » Thu Jan 14, 2016 8:52 am

Yes, every time you create a new macro, the default 0.3 applies and you have to set it to .1.