Rc5 vs RC-5 ?

This is the JP1 beginners forum. There's no such thing as a stupid question in here, so post away, but this forum is just for JP1 users and people considering JP1, non-JP1 users please use the appropriate forum above!

Moderator: Moderators

Post Reply
hefvogt
Posts: 2
Joined: Fri Jan 23, 2015 9:13 am
Location: Netherlands

Rc5 vs RC-5 ?

Post by hefvogt »

Are RC5 and RC-5 protocols different? In learning mode, my Helvar Digidim (for switching and dimming light) apparently sends RC5 protocol. The target remote functions as expected.
In trying to copy functions to a device (update file) I can't select RC5 protocol; RC-5 is available. I chose this, but the resulting device does not work.
Similarly created NEC devices do work, so I guess my device creating method is OK. Any suggestions?
Top
vickyg2003
Site Admin
Posts: 7109
Joined: Sat Mar 20, 2004 12:19 pm
Location: Florida
Contact:
Contact vickyg2003

Re: Rc5 vs RC-5 ?

Post by vickyg2003 »

hefvogt wrote:Any suggestions?
Zip together the relevant files, (the learns, the upgrade and the IR/RMIR file), and post them in the diagnosis section. Then post a link to that file in this thread and we will have a look.
Top
hefvogt
Posts: 2
Joined: Fri Jan 23, 2015 9:13 am
Location: Netherlands

Re: Rc5 vs RC-5 ?

Post by hefvogt »

vickyg2003 wrote:
hefvogt wrote:Any suggestions?
Zip together the relevant files, (the learns, the upgrade and the IR/RMIR file), and post them in the diagnosis section. Then post a link to that file in this thread and we will have a look.
Thanks for your attention. In collecting files to zip them to you I found an error in the device definition: the setup code had accidently been set to 0000, where 2104 was intended. Sorry for the inconvenience.
Top
Post Reply

Return to “JP1 - Beginners”