Manual Programming - Sky Remotes
Sky/Sky+ Remote Control manual programming codes (not 100% sure about SkyHD)
Installation (Engineer’s) Menu
Choose "Services" on the remote control. Then press 4, then 01 followed by SELECT.
TV, SELECT+Green (Simultaneous press of "SELECT" & "Green") commands
“MACRO” functions (e.g. to force the TV to a particular channel for Sky viewing via RF input)
a. XXXX (1-4 digits), SELECT: will have the remote set the TV to channel XXXX whenever Sky, TV guide, Box Office, Services or Interactive is pressed;
b. SELECT: Clears this Macro;
TV, SELECT+Red commands
TV Code set functions
a. XYZ, SELECT: sets 3-digit “Direct set” code to TV Device button;
b. TV, WXYZ: sets 4-digit “Brand Set” code to TV Device button. Then
i. Standby - tests code, if TV turns OFF, skip to iii, if not, go to ii;
ii. TV, Standby – tests the NEXT code for that brand, if TV turns OFF, go to iii, if not, repeat ii;
iii. SELECT - locks in your TV code;
c. 990,(1, 2, 3): Blinks back (1st, 2nd, 3rd) digit of set TV code;
d. 999: Master reset;
TV, SELECT+Blue commands
Sky remote mode/aspect ratio functions
a. 0: sets remote to Sky mode;
b. 1: sets remote to DUAL Sky/Sky+ mode (¿according to some posts?);
c. 2: sets remote to Sky+ mode;
d. 1 (0,2): sets RF output to Widescreen (4:3) default (¿according to one posting?)
TV, SELECT+Yellow commands
Key Move functions
a. 994, A, B: Copies Key A to Key B (resets Key A if use B=A)
b. 994, SELECT, XYZ, A: Assigns Advanced code (or EFC) XYZ to Key A
TV, SELECT+0 commands (not Sky, but Sky+ (maybe SkyHD) remote): AMP Code set functions
a. WXYZ: sets 4-digit “Brand Set” code to AV Amplifier;
b. Left Arrow - tests code, if AMP turns OFF, press SELECT, if not, go to a;
TV, SELECT+1
Sets volume punch-through to AMP device;
TV, SELECT+2
Cancels Volume Punch-Through
TV, SELECT+“i” commands (for SkyHD remote)
a. 0: sets SkyHD remote to Sky mode (¿an educated guess?);
b. 1: sets SkyHD remote to Sky+ mode (¿an educated guess?);
c. 2: sets SkyHD remote to SkyHD mode;
TV codes at: http://www.digitalspy.co.uk/satellite/remote/
AMP codes at: http://www.morlocks.co.uk/remote-setup.htm
Most of this info from: http://www.satcure.co.uk/tech/digicode.htm