Page 1 of 1
2 Replay 5040's and URC 8810w
Posted: Thu Apr 29, 2004 5:51 pm
by Indy1979
I've been messing with this for a little while now and can't get the 2 replays to respond seperatly when I select the device and push power. I've set the replays to remote machine codes 1 and 2 and have done the same thing in keymap master. What am I doing wrong? Does anyone have the file already setup to control 2 replays in the same room?
Sam
Posted: Thu Apr 29, 2004 6:18 pm
by The Robman
Many of us use multiple Replays in the same location (including myself). If you really have done what you describe, then it should work. The fact that it doesn't means you've missed a step somewhere, but i can't tell where from the limited info in your post.
Posted: Thu Apr 29, 2004 7:16 pm
by Indy1979
EDIT!!!!!
Ok, got it figured out.
For replay 1:
Device setup code: 1614
Device code 1
Unit code 1
For replay 2
Device setup code 1615
Device code 1
Unit code 2
Anything wrong with this setup?
Sam
Posted: Thu Apr 29, 2004 9:07 pm
by The Robman
Assuming the selected protocol is one of the Replay protocols, that should work. Is that not what you were doing before?
Posted: Sun May 02, 2004 4:19 pm
by Indy1979
No, there wasn't really any usable info on the exact procedure. I kind of had to figure it out for myself.
Sam