2 Replay 5040's and URC 8810w

Indy1979 · Post by **Indy1979** » Thu Apr 29, 2004 5:51 pm

I've been messing with this for a little while now and can't get the 2 replays to respond seperatly when I select the device and push power. I've set the replays to remote machine codes 1 and 2 and have done the same thing in keymap master. What am I doing wrong? Does anyone have the file already setup to control 2 replays in the same room?

Sam

Post by **The Robman** » Thu Apr 29, 2004 6:18 pm

Many of us use multiple Replays in the same location (including myself). If you really have done what you describe, then it should work. The fact that it doesn't means you've missed a step somewhere, but i can't tell where from the limited info in your post.

Indy1979 · Post by **Indy1979** » Thu Apr 29, 2004 7:16 pm

EDIT!!!!!

Ok, got it figured out.

For replay 1:
Device setup code: 1614
Device code 1
Unit code 1

For replay 2
Device setup code 1615
Device code 1
Unit code 2

Anything wrong with this setup?

Sam

Post by **The Robman** » Thu Apr 29, 2004 9:07 pm

Assuming the selected protocol is one of the Replay protocols, that should work. Is that not what you were doing before?

Indy1979 · Post by **Indy1979** » Sun May 02, 2004 4:19 pm

No, there wasn't really any usable info on the exact procedure. I kind of had to figure it out for myself.

Sam