View previous topic :: View next topic |
Author |
Message |
JezW
Joined: 26 Nov 2015 Posts: 156
|
Posted: Sun Mar 08, 2020 7:31 am Post subject: URC 6440 - not responding at all after failed upload [FIXED] |
|
|
Hi all
I've got the above remote setup with the extender and lots of fancy macros Thanks again to everyone a few years ago who eventually got me there...!
I was just making some minor changes in RMIR and uploading to the remote, but the cable got disconnected during the upload. So I uploaded again, but now the remote won't respond to anything.
-Remote still comes up in My Computer and RMIR settings still upload fine to the remote
-TV button doesn't flash twice when I disconnect the remote from the PC
-Buttons don't light up when pressed
-Remote doesn't seem to respond to anything now...
What do I do? |
|
Back to top |
|
|
JezW
Joined: 26 Nov 2015 Posts: 156
|
Posted: Sun Mar 08, 2020 7:43 am Post subject: |
|
|
Crisis averted...
Found this on another thread from mathdon
"Remove the batteries from the remote, connect the remote to the PC and THEN replace the batteries. It will now show as an external drive. Then copy a valid settings.bin file to the remote before disconnecting it from the PC. As far as I am aware, it is not possible to get the remote into a state from which even this will not work."
The bit in bold worked for me. |
|
Back to top |
|
|
|