Page 1 of 1
Pause Protocol for RM
Posted: Sat Mar 08, 2008 5:56 pm
by bigbge
My remote is a URC-1067, Comcast DVR remote. I got the rdf file for this and selected it with RM (1.83). Under Protocol I do not see the Pause Protocol like in KM. There was a post last year that said it was there in RM between Panasonic and Pioneer. I don't see it. Is it possible because of the rdf?
I can't use KM because this remote is not supported.
Posted: Sun Mar 09, 2008 5:19 am
by Capn Trips
It looks like a standalone Pause protocol has not yet been written for JP1.2 remotes. Maybe vickyg, who has written a JP1.2 extender previously which includes a Pause protocol, can help you. She's the JP1.2 expert.
Posted: Sun Mar 09, 2008 6:19 am
by vickyg2003
She's the JP1.2 expert.
Nah, she's only a wannabe, but she's trying hard. Mike and Binky are the true JP1.2 experts.
I couldn't tell which 1067 we were talking about here. There are so many versions. Are you talking about the JP1.2 version? How big a delay are we talking about here? Sometimes just rearranging your commands can do it. If you need a few seconds, you might want to try the zenith Pause trick.
There is an adjustable pause in the extender, but I haven't coded it to be a standalone protocol. This would probably be a good project to help me figure out how to use protocol builder.
Posted: Sun Mar 09, 2008 8:47 am
by bigbge
Yes, the remote is JP1.2
A nominal one second delay would be good, I can always string a few.
Posted: Sun Mar 09, 2008 10:07 am
by mdavej
Will the one for the
10820 not work?
This one works fine in my JP1.3 remote. I just takes 2 bytes instead of one, i.e., a 1 second pause is $10 $92 rather than just $10.
Posted: Sun Mar 09, 2008 11:12 am
by vickyg2003
No that 10820 protocol is not generic. I do believe there is a generic protocol for the 8820 that should work for the URC-1067, but its not that one.
Posted: Sun Mar 09, 2008 2:31 pm
by mr_d_p_gumby
The JP1.2 Pause protocol itself in KM is generic (to all JP1.2 remotes). Since KM does not support the Comcast 1067 until the next release, try this for now:
Code: Select all
Upgrade Code 0 = 0F CF (Cable/1999) Pause (KM v9.13)
FB 00 01
KeyMoves
A6 F0 04 07 CF 00 92«delay 1s»
End
Upgrade Protocol 0 = 01 FB (HCS08) Pause Protocol (Special) (KM v9.13)
20 03 00 00 01 A6 F4 AE 29 CD FF A1 3B 60 F6 81
End
This puts a keymove on shift-A with a 1-second delay (EFC=00146). Once you have it in IR you can edit it to move it to a different key. You can use KM to calculate the EFC if you want to adjust the time delay. Set it for the URC-8820 and enter the delay OBC on the functions sheet, then KM wil calculate the 5-digit EFC that you can enter in IR.
I didn't have time to check, but RM should be able to generate the Pause protocol for this remote as long as the RDF file is there.