JP1 Remotes

Does anyone have device upgrade for TV-0463? I have Sansui TV and the remote is broke. I would like to program my URC-6131 extender to operate the TV.
Thanks

Alkap

0463 is already in the 6131.

whompus wrote:0463 is already in the 6131.

There's some advanced codes listed as well.

I run extender on 6131 so regular codes are not available.
I have tried the extended codes without success, may be I am doing something wrong. I will recheck.
Thanks for the replies.
Alkap

alkap wrote:I run extender on 6131 so regular codes are not available.

What makes you think that? You can still access all of the built-in setup codes even with the extender.

alkap wrote:I run extender on 6131 so regular codes are not available.

You do have to use ir.exe to select them since the "set/setup" key won't put you into setup mode under the extender.

Thanks for all the replies, however, I am trying to program it as device 8 on 6131 extender. I don't have any regular keys open other than device 8.

I am pretty sure I am using KM correctly to define all the keys, the problem might be protocol. I am using the following

Protocol Name NEC1
Main Device 1
Sub Device 1
Parm 00

Protocol ID 005A
Fixed Data 00 7F 7F

Is this correct?
Thanks
Alkap

Mark Pierson wrote:

whompus wrote:0463 is already in the 6131.

There's some advanced codes listed as well.

Also, I assumed these codes to be EFC's, is it correct? Or are they OBC's?
Thanks
Alkap

alkap wrote:Thanks for all the replies, however, I am trying to program it as device 8 on 6131 extender. I don't have any regular keys open other than device 8.

On the General tab in IR just set the dev8 device button to TV/0463.

Protocol Name NEC1
Main Device 1
Sub Device 1
Parm 00

Protocol ID 005A
Fixed Data 00 7F 7F

TV/0463 is NEC2, dev: 134, sub: 5, parm: 21. That should give Fixed Data of 21 9E 5F.

I assumed these codes to be EFC's

Correct.

Thanks, worked like a charm, Merry Christmas and a Very Very Happy New Year to you and your family

Alkap