Page 1 of 1
#value! error when choosing RCU810 and SAT
Posted: Sun Sep 10, 2006 12:05 am
by dick99999
When trying to set up a new dev ugrade I get this error #value! in cell F8 of the setup sheet. It appears right after choosing the RCU810 remote and then dev type Sat. Is it KM v9 or my setup?
Re: #value! error when choosing RCU810 and SAT
Posted: Sun Sep 10, 2006 6:14 am
by Mark Pierson
dick99999 wrote:Is it KM v9 or my setup?
It's a minor bug in KM. An updated version should be available later today.
Posted: Sun Sep 10, 2006 1:27 pm
by dick99999
Thanks very much Mark, I have downlooded KM v9.05 and can indeed load my old v8 upgrades defs again.