Page 1 of 1
RM - External Functions - Hex - Multiple byte?
Posted: Sun Nov 16, 2003 3:51 pm
by pH7_jp1
What is the correct syntax for entering a multiple byte hex command in the EFC/Hex field on the External Functions sheet
I'm sorry if I am asking a question with an easy to find answer. I did search here and at sourceforge. Is there any help file where this answer can be found?
Thanks,
Phil
Posted: Sun Nov 16, 2003 6:03 pm
by Mark Pierson
Just enter the hex bytes separated by spaces, i.e. "00 11".
I tried that.
Posted: Sun Nov 16, 2003 7:42 pm
by pH7_jp1
Thanks for your reply Mark, but that was the first thing I tried. When I do that, it won't let me leave the field. If I type Enter, it does not update the field the same way it does when I type only one number and clicking on other tabs after that has no effect. RM won't let me do anything else until I go back to a single number and then all works well again.
I just realized that my file started as an import from a KM file. I will try starting a fresh one and see if that fixes anything.
Posted: Sun Nov 16, 2003 8:46 pm
by gfb107
You need to set the type to Hex before you can enter a hex value.
The valid types are EFC and Hex.
Posted: Sun Nov 16, 2003 9:03 pm
by pH7_jp1
Excellent! Thank you. I never even noticed that the field was there.
