Page 1 of 1
Sky Digibox URC-1610-10
Posted: Sat Apr 16, 2005 10:54 am
by Jiteshprm
I need to know if this remote from a Sky Digibox, an URC-1610-10, which does not have any obvious JP1 connection.Anyone knows how to hook this remote for Jp1?
A picture from it is attached:
http://img177.echo.cx/img177/4479/urc161011el.jpg
Posted: Sat Apr 16, 2005 11:00 am
by gfb107
I can't help, other that to suggest that you post a picture of the other side of the PCB as well.
Posted: Sat Apr 16, 2005 3:40 pm
by Jiteshprm
Here goes attached the other part of the remote, the IC marking is:
3104 208 83741
rc1680-1600-02
2H65k
[Motorola logo](M) ctcthk0323
http://img210.echo.cx/img210/1546/urc1610front5qx.jpg
Posted: Sat Apr 16, 2005 4:11 pm
by The Robman
There's no EEPROM, so there's no way to know if the chip is programmed to support one.
Posted: Thu Aug 11, 2005 8:23 am
by Mr Hat
From looking
here, it looks like your remote can probably have JP1 added to it.
As well as the 6 pin header and memory device, I think you'll also need to add two surface mount resistors (located in the spaces at the top right of your first photo) as these are present on the other remote. You already have the 104 and 474 resistors, plus the capacitor fitted, so it's a fair bet that two 103 resistors should do the trick.
