Page 1 of 1
Monoprice HDMI switchers.
Posted: Tue Mar 09, 2010 3:57 pm
by sweller
Hi, Folks.
Looking at the offerings in the file section, I notice there doesn't seem to be any discrete ON/OFF codes for these. Before I go off trying to reinvent a square wheel, is that because these boxes don't accept or can't recognize discrete ON/OF codes?
Specifically, I'm trying to come up with the codes for the 4x1 with audio out.
TIA!
Posted: Tue Mar 09, 2010 6:46 pm
by The Robman
I don't know what the other users have tried, but these boxes use the NEC1 protocol, so testing the unused OBCs looking for discrete codes would not be too hard.
Posted: Wed Mar 10, 2010 1:38 pm
by sweller
Worth a try and it can't hurt. Thanks!
Monoprice HDX401TA codes
Posted: Wed Mar 17, 2010 1:36 pm
by jeajea
If your switch is a Monoprice HDX401TA HDMI the following file contains the input 1, 2, 3, and 4 codes.
https://www.hifi-remote.com/forums/dload ... le_id=8166
It appears that the 401TA uses different codes than the other Monoprice switches because the codes that Logitech has for the 401 in the Harmony database doesn’t work for the 4 inputs.
The following file also contains the list of codes for the Snapstream firefly mini that you can eliminate in your search for discrete on and off codes for the switch (both the 401TA and the mini use the same protocol allowing them to be combined in one device upgrade). The only conflict I have found is the mini stop code causes the 401TA to lockup.
https://www.hifi-remote.com/forums/dload ... le_id=8165