JP1 Remotes

split from here:
https://www.hifi-remote.com/forums/viewt ... p?t=103727

jackching wrote:I do have a couple of questions though about bell/dishnetwork upgrades.

1: Is there a simple way to change the remote address through rmir?

2: Is there a more recent upgrade for the bell/dishnetwork remotes? I can't seem to find an upgrade that includes page up/down for scrolling a page at a time through the program guide.

I don't know the answers, so hopefully some other expert will help. But for this sort of thing, you may have to do the research yourself. I show that we have about 41 Dish Network upgrades, did you look through all of them for the page up/down buttons? Worst case scenario, you could try hunting for them by trying the unused OBCs.

As for changing the remote address, you may need to do some Googling on that.

ok so after taking a break I came back to this and discovered that the remote address can be changed by simply entering the remote address in the remote address slot under the setup tab in device upgrade editor.

Also found an upgrade with page up and page down for the guide:
https://www.hifi-remote.com/forums/dload ... le_id=6494

My upgrade is pretty complete:
https://www.hifi-remote.com/forums/dload ... le_id=8983

mdavej wrote:My upgrade is pretty complete:
https://www.hifi-remote.com/forums/dload ... le_id=8983

In the earlier thread Jack said that one didn't work for him. Jack, could you say what didn't work about it?

jackching wrote:ok I am just overthinking now. I tried to load this upgrade and it didnt work.
https://www.hifi-remote.com/forums/dload ... le_id=8983

I'm just at the point of over thinking now. Back at it tomorrow.

Thanks for the correction. I didn't read the whole thread.