JP1 Remotes

Many thanks to Chuliu. It is working now. and thank you to everyone who helping on this "power on/off" button issue.

Barf , you are right , I was using modulating receiver (TSOP-*) ,therefore it is not working. I will try to get a non-demodulating receiver TSMP58000 to test it.

by the way ,just ...

Hi Barf

Sorry that I didn't described clearly regarding the problems. I finally got the Arduino working on the windows . The problem that cause it is not working is due to the src\GirsLite\GirsLite.cpp, I thought I have to delete the contents of the GirsLite.cpp "../Girs/Girs.cpp" then put the new ...

Hi Barf

Thank you for your advise on Windows version problem, however I still can't make it work. therefore I tried to build it on linux, however still no luck, I got the message Error compiling for board Arduino/Genuino Uno. and error is regarding the quote below:
/home/charlie/Downloads ...

I tried to use my Arduino box to capture the IR code with IrScrutinizer as Chuliu suggested. It require to load the Girslite on Arduino. however I got problem with that. it keep shows

GirsLite.cpp:1: error: 'src' does not name a type

src/Girs/Girs.cpp

#it was original ../Girs/Girs.app on the ...

I will mail the remote controller to Chuliu , and let him figure out what is the correct code for that power button. by the way , it can't power on the STB as well while it is on"power off" mode or "standby" mode. I have mail a .conf file which is the create by "Digizon BOX" (similar to slingbox ...

yes, I did try this one. This one is not working at all on STB-9832C6 , even for changing the channels.

Hi

I have a latest Inspur_STB-9832C6 STB for my cable TV. I have tried the code which downloaded from JP1 Forum. The code was for Inspur_STB-9832C , which including S1376_PL.BIN. The code is working for switching channels , however the most important one is not working - the "power on/off " button ...