MENU     Set Up     Searching For Your Code     Blinking Back the Code
Volume Lock    

How to Program your "Millenium-3" remote



Set Up

After getting the proper codes from the list below, use the following instructions to enter them into your remote.

  1. PRESS the button for the device you want to program (TV,VCR,CABLE,etc.) then RELEASE.
  2. PRESS and HOLD the SETUP button until the red LED flashes twice, then RELEASE.
  3. ENTER the 4 digit code for your brand.
  4. You should receive 2 quick flashes after entering your code.
  5. PRESS the POWER button to test the code. (On VCR,LD,and CD players use PLAY)

4 Digit Brand Code

CABLE
SATELLITE
TELEVISION
VCR

menu

Searching For Your Code

If you have tried all of the set-up codes for your brand of equipment, or your brand is not listed, and you are still not able to get the unit to respond, try the following procedure to search for your code.
  1. PRESS the button for the device you want to program (TV,VCR,CABLE,etc.) then RELEASE.
  2. PRESS and HOLD the SETUP button until the red LED flashes twice, then RELEASE.
  3. ENTER 9-9-1 (two blinks on the remote)
  4. ALTERNATE slowly between the Curson Up key and the TV button STOP when device turns off.
    NOTE: In the search mode, the Millenium3 will send IR codes from its library to the selected component starting with the most popular code first
  5. PRESS the SETUP button and RELEASE it to lock in the code for your device.
  6. To search for the codes of other components, repeat steps 1 through 5, substitute the appropriate key (i.e., VCR or CBL) for the component for which you are searching.

menu

Blinking Back the Code:

  1. PRESS the device (TV,VCR,CABLE,etc.) button - RELEASE
  2. PRESS and HOLD the SETUP button until the red LED flashes twice, then RELEASE.
  3. PRESS 9 - 9 - 0.
  4. PRESS 1, carefully COUNT the number of blinks. (1st digit)
  5. PRESS 2, carefully COUNT the number of blinks. (2nd digit)
  6. PRESS 3, carefully COUNT the number of blinks. (3rd digit)
  7. PRESS 4, carefully COUNT the number of blinks. (4th digit)
If the remote DOES NOT blink it means the number is 0.
This is your 4-digit setup code.

menu

Volume Lock

  1. PRESS and HOLD the SETUP button until the red LED flashes twice, then RELEASE.
  2. PRESS 9 - 9 - 3
  3. PRESS the device button from where you want volume to be controlled.


All Material Copyright Universal Electronics Inc.
Any questions about the products should be directed to cablehelp@ueic.com