The remote is preprogrammed at the factory to operate an RCA TV, VCR, DVD and satellite receiver, and Pioneer CD and audio devices. To control devices other than the default brands, perform the following steps and repeat them as needed for each device to be programmed; otherwise skip this section.

Direct code set up
TO SET UP THE REMOTE FOR YOUR TELEVISION:

1. Find your device code above. Codes are listed by device type and brand name. The most popular code for each brand is listed first.

2. Make sure your television is switched on.

3. Press and release TV.

4. Hold down P for at least 3 seconds. The bottom of the IR Indicator blinks twice, and a circle appears around P.

5. Enter your four-digit code using the number keys. The bottom of the IR Indicator blinks once after each of the first three digits are entered. After the fourth digit, it blinks twice to confirm that a valid four-digit code has been entered.

6. Aim your remote at your television and press POWER. If your television switches off, your remote is ready to control your television.

1. Find the codes for the devices you want to program in Setup Codes for TV/VCR Combos and write them down.

2. Turn on the TV/VCR Combo and insert a video-cassette.

3. Press and release VCR.

4. Hold down P for at least 3 seconds. The bottom of the IR Indicator blinks twice, and a circle appears around P.

5. Enter your four-digit code using the number keys. The bottom of the IR Indicator blinks once after each of the first three digits are entered, and blinks twice after the fourth digit to confirm that a valid four-digit code has been entered.

6. Aim your remote at your TV/VCR and press POWER. If your television switches off, your remote should be ready to control your TV/VCR.