The remote comes preprogrammed to operate an RCA TV, VCR, and satellite receiver, and a Pioneer DVD player. To control devices other than the default brands, follow these steps; otherwise, skip this section.

Before proceeding, find the codes for the devices you want to program in Manufacturer’s Codes and write them down.
NOTE: To control a TV/VCR combo, see the next section.

1. Turn on the device (e.g., VCR or DVD player) and, if necessary, load media (e.g., cassette or disc).

2. On the remote control, press a device key (i.e., DVD, VCR, TV,or CBL/SAT).

3. Press and hold P until the red LED blinks twice, then release P.

4. Enter the first four-digit code for your device. If the code is correct, the LED blinks twice.
   NOTE: If the LED does not blink twice, repeat steps 2 through 4 and try entering the code again.

5. Aim the remote control at the device and press POWER (or PLAY,ifthe device does not have a POWER key). The device should turn off. If it does not respond, repeat steps 2 through 5, trying each code for your brand until you find one that works.

6. Repeat steps 1 through 5 for each device you want to control. For future reference, write down each working device code.

Before proceeding, find the codes for the devices you want to program in Setup Codes for TV/VCR Combos and write them down.

1. Turn on the TV/VCR Combo and insert a videocassette.

2. On the remote control, press VCR.

3. Press and hold P until the red LED blinks twice, then release P.

4. Enter the first four-digit code for your device. If the code is correct, the LED blinks twice.
   NOTE: If the LED does not blink twice, repeat steps 2 through 4 and try entering the code again.

5. Aim the remote control at the device and press POWER (or PLAY,ifthe device does not have a POWER key). The device should turn off. If it does not respond, repeat steps 2 through 5, trying each code for your brand until you find one that works.
   NOTE: If you locate a setup code that works, but requires a separate TV code, you must program the TV code into the remote separately to control the volume. For VCR/TV combos that use separate TV codes, TV volume is controlled by pressing VCR first, then TV. After that, use VOL+ (or VOL-) to raise (or lower) the TV volume. See "Changing Volume Lock" for other volume control options.

6. For future reference, write down the working TV/VCR combo code.