15-2115, 5-IN-ONE REMOTE
Setup Codes For Audio Amplifiers:
Setup Codes For Audio Receivers:
Setup Codes For Cable Converters:
Setup Codes for CD Players:
Setup Codes for DVD Players:
Setup Codes For Home-Theater-In-A-Box Devices:
Setup Codes For Satellite Receivers:
Setup Codes For TVs:
Setup Codes For TV/VCR Combos Devices:
Setup Codes For VCRs:

Device Types
You can use the remote control's device keys to control these types of devices:
Device Key to UseDevice Type
VCRVCR, TV/VCR Combo, or PVR (Personal Video Recorder)
CBL/SATCable Converter or Satellite Receiver
DVDDVD Player
AUXAudio Amplifier, Audio Receiver, CD Player, Home Automation, or Home Theater-In-A-Box (HTIB)

Programming A Device

The RadioShack 5-in-One remote comes preprogrammed to operate an RCA TV, VCR, and cable converter, and a Pioneer DVD player and audio receiver. To control devices other than the default brands, follow these steps; otherwise, skip this section.

Before proceeding, find the codes for the devices you want to program above.

NOTE: To control a TV/VCR combo, see "Programming A TV/VCR Combo" below.

  1. Turn on the device (e.g., VCR or DVD player) and, if necessary, load media (e.g., cassette or disc).

  2. On the RadioShack 5-in-One remote, press a device key (i.e., CBL/SAT, VCR, DVD, AUX,or TV).

  3. Press and hold P until the red LED blinks twice, then release P.

  4. Enter the first four-digit code for your device. If the code is correct, the LED blinks twice.
    NOTE: If the LED does not blink twice, repeat steps 2 through 4 and try entering the code again.

  5. To verify the code works, aim the RadioShack 5-in-One remote at the device and press POWER (or PLAY, if the device does not have a POWER key). The device should turn off. If it does not respond, repeat steps 2 through 5, trying each code for your brand until you find one that works. If you cannot find a code that works, see Searching For Your Code on page 16.

  6. Repeat steps 1 through 5 for each device you want to control.
Quick Set Up Of Your TV/VCR Combo

Before proceeding, find the codes for the device you want to program in Setup Codes for TV/VCR Combos.

  1. Turn on the TV/VCR Combo and insert a videocassette.

  2. On the RadioShack 5-in-One remote, press VCR.

  3. Press and hold P until the red LED blinks twice, then release P.

  4. Enter the first four-digit code for your device. If the code is correct, the LED blinks twice.
    NOTE: If the LED does not blink twice, repeat steps 2 through 4 and try entering the code again.

  5. To verify the code works, aim the RadioShack 5-in-One remote at the device and press POWER (or PLAY, if the device does not have a POWER key). The device should turn off. If it does not respond, repeat steps 2 through 5, trying each code for your brand until you find one that works.
    NOTE: If you locate a setup code that works, but requires a separate TV code, you must program the TV code into the remote separately to control the volume. For VCR/TV combos that use separate TV codes, TV volume is controlled by pressing VCR first, then TV. After that, use VOL+ (or VOL-) to raise (or lower) the TV volume.