Wireless Infrared (15-1959) Installation Faxback Doc. # 7081
Remote Control Extender
The Radio Shack Wireless Infrared Remote Control Extender includes a
transmitter and a receiver. The transmitter senses the infrared signals
from your audio/video equipments remote controls and converts them back to
identical infrared signals, then relays them to the audio/video equipment.
INSTALLING THE RECEIVER
Follow these steps to install the receiver.
1. Place the receiver in front of the audio/video equipment and position
it as follows:
A: Within 20 feet of the audio/video equipments remote sensor.
B: With the receivers front directly in front of the audio/video
equipments remote sensor.
2. Fully extend the telescopic antenna.
NOTE: The extender system's LEDs (particularly the transmitter's) might
blink occasionally. This is caused by interference in the local
vicinity and is normal.
(smc-02/28/94)