Four-In-One Remote Control  (15-1909)   Setting Up    Faxback Doc. # 6722

Follow these steps to set up the 4-in-1.

1.  Remove the battery compartment cover and install four fresh AAA
    Alkaline batteries (Radio Shack Cat. No. 23-555) as indicated by the
    illustration in the battery compartment.

Note:  Do not place objects on top of the remote control after you install
       the batteries.  This can press down keys and reduce battery life.

2.  Write down the codes for your original remote controls on the provided
    label.

3.  Press the device key for the remote you are replacing (TV, VCR, AUX,
    or CBL).

4.  Press the <DEVICE> key, press and hold the <P> key until the LED 
    blinks once.  Continue to hold down the <P> key while entering the  3
    digit code.  The URC will flash twice when it accepts the code.
    Release the <P> key.   Library step through code is 991, then <POWER>
    then <DEVICE> repeatedly.  Display code # is 990, followed by # of
    digits.

Repeat Steps 2-4 for additional devices.

Note:  The punch-through feature is automatically turned on for the TV's
       volume and mute controls.  This means that when you select CBL and
       press one of the volume buttons or the MUTE button, the remote
       actually sends the codes to the television, and not the cable
       converter.  If you want to use your cable converter's volume and
       mute controls, disable the punch-through feature for these buttons.

       If the remote does not operate the device, try other codes 
       manufacturer's codes for your brand of TV, VCR, or cable box.

Note:  The red indicator at the top of the 4-in-1 flashes twice when you
       enter a code that it recognizes.  (This does not mean that it is
       the right code for your device, however.)

When the 4-in-1's range decreases or the 4-in-1 operates erratically,
replace the batteries.

Caution:  Be sure to have the fresh batteries ready to install before you
          remove the old batteries.  The 4-in-1's memory only lasts about
          a minute without the batteries.  If the memory is lost, simply
          re-enter the 3-digit manufacturer's codes for your remote
          control products.


(br/ir-05/15/96)