15-1990, 3-in-One Pocket Remote Control

Cable Converters:
Televisions:
VCRs:
TV/VCR Combinations:


Device Types
You can use the remote control's device keys to control these types of devices:
Device Key to Use Device Type
TV TVs
VCR VCRs and TV/VCR combinations
CBL Cable converters



Setting Up Your Remote Control
  1. Refer to codes above to setup your 3-in-One remote.
    Note: Some manufacturers have several codes listed. Try each until you find the right one.
  2. Press the device key for the type of remote you are replacing (TV, VCR, or CBL). The red light blinks.
  3. Hold down P until the red light blinks twice, then enter the 4-digit code in Step 1 using these keys:

    Press To Enter
    This Number    		 Example
      VOL +   1 To replace a TV’s remote control (manufacturer’s code 1432), press TV, hold down P until the red light blinks twice, then press VOL +, CH –, CH +, and VOL –.
    When the red light blinks twice, the remote control has accepted the code.
    Note: If the code you entered is invalid, the red light blinks once.
      VOL –   2
      CH +   3
      CH –   4
      MUTE   5

Point the remote control at your device and press POWER. Your device should turn off (or on, if it was off).
If the remote does not operate your device, try the other codes listed above for your brand of TV, VCR, TV/VCR combination, or cable converter.

Repeat Steps 2–4 for additional devices.

More RadioShack Remote Control Codes Can Be Found Here.