7-in-One IR/RF Remote Control
(15-1995)                 Troubleshooting            Faxback Doc. # 58329

Problem                       Solution

Display begins to fade,       Replace the batteries with four fresh AAA 
does not appear, or the       alkaline batteries.
red light blinks five
times when you press a key.

The 7-in-One does not         Try all of the codes listed for your brand 
operate your device.          of device in the "Setup Codes" section.  If
                              this does not work, try searching for your
                              code (see "Searching for a Code" in Faxback
                              Doc. # 58327).  Make sure the device you are
                              setting up can be operated with an infrared
                              remote.

The 7-in-One is not per-      Try all of the codes listed for your brand 
forming commands properly.    of device in the "Setup Codes" section. Many
                              set-up codes may allow some degree of
                              operation.  However, only one set-up code
                              will work correctly with your device.

You make a mistake when       During any set up procedure, except for 
setting up your 7-in-One.     timed sequences, the ESCAPE key will Return
                              you to the DEVICE and TIME screen without
                              saving any of the entered information.  If
                              you make a mistake when setting up the timed
                              sequence, return to the timed sequence menu
                              and delete the incorrect sequence.

VCR not recording.            As a safety feature on the 7-in-One, you
                              must press the REC key twice to begin 
                              recording.

CH +/- (Channel Up/Down)      Due to RCA design (1983-1987), only the
and LAST not working for      original remote will operate these 
your RCA TV.                  Functions.

Problems changing channels.   If your original remote required an ENTER
                              keystroke when changing channels, press the
                              ENTER key on the 7-in-One after you enter
                              the channel number.

The red light blinks when     Press the appropriate device key (CD, CBL,
you press a key but you       VCR, TV, TUNER, AMP, SAT, PLUG 'N POWER) for
receive no response from      the device you are trying to operate.  Make
your device.                  sure you aim your 7-in-ONE at your device
                              and that you are within 15 feet of the
                              device before using your remote.

You can turn your audio       Some audio components might need both a
component on and off and      Tuner/Receiver Code and an Amplifier Code
control its volume, but you   (see Faxback Doc. # 58328) to control all
cannot change preset          features of your audio component.
channels.

Your satellite receiver does  The codes listed in this manual are set up 
not respond to the codes      to operate your satellite receiver on the
listed in the manual.         first or second addresses only.  Make sure
                              the satellite receiver you are setting up
                              can be operated with an infrared remote.

The 7-in-One does not         Some Bang & Olufsen and other manufacturers'
operate Bang & Olufsen        equipment operate at frequencies higher than 
audio equipment.              100 kHz.  The 7-in-One will not operate such
                              devices.

(BR EB 1/20/00)