4-In-One Remote Control
(15-1991)                 Operation                  Faxback Doc. # 58257

1.  Press the device key for the device you want to control.

2.  Point the remote control toward the device you want to control, then
    press the desired command keys. 

3.  Repeat Steps 1 and 2 for all other devices you want to operate.

    Note:  The command keys on the remote control work the same as the 
           keys on the original remote control; however, the labeling 
           might differ slightly. 

4.  To turn off the last device you selected, press POWER. To turn off 
    other devices, press the device key for the device you want to turn 
    off, then press POWER.

Converting Device Keys

You can use the 4-in-one Remote to operate a second TV or VCR (or other 
components) for a total of up to four devices.  To do this, you must first 
convert an unused device key (TV, VCR, CBL, AUX) to operate each 
additional device.  For example, to convert AUX to operate a second TV:

1.  Hold down P until the red light blinks twice.

2.  Press 9 9 2.  The red light blinks twice.

3.  Press TV.

4.  Press AUX.  The red light blinks twice. 

5.  Program the converted device key (AUX) with the code for the second 
    TV.  (See "Setting Up Your Remote Control" in Faxback Doc. # 58256.)

Repeat these steps for each key you want to convert.  To convert a key 
back to its original function, repeat Steps 1-2, then press AUX twice.

Punch-through

The punch-through feature lets you alternately control two different 
devices without pressing the device keys for each one. 

A TV is often the only device that uses the volume keys.  Punch-through 
allows you to control the TV's volume while the 4-in-One is in any device 
mode.  With punch-through on, if you press VCR and use your volume keys, 
the 4-in-One will control the TV's volume instead of the VCR's.

Turning Punch-Through Off/On

If your cable converter or VCR has volume control, you might want to turn 
off punch-through so you can use the cable converter's or VCR's volume 
instead of the TVs.

To turn off punch-through, hold down P until the red light blinks twice.  
Press 9 9 3, then VOL +.  The red light blinks four times.

Now, when you want to control the volume through your cable converter, 
press CBL before using the volume keys.  If you want to control the volume 
through your VCR, press VCR before using the volume keys.

To turn punch-through back on, hold down P until the red light blinks 
twice.  Press 9 9 3, then the key for the device you want to control all 
volume (TV, for example).  The red light blinks twice.

Now, the device you chose will control volume whenever you press a volume 
key.

Channel Scan

You can use your remote control to scan through the channels of your TV, 
VCR, or cable box.

1.  Press the device key for the device with the channels you want to scan 
    (TV, VCR, or CBL).  The red light blinks.

2.  Point your 4-in-One Remote at the device you want to scan and press 
    SCAN.

    The remote control repeatedly scans through the device's available 
    channels, stopping on each channel for about 3 seconds.

3.  When you see a channel you want to watch, press any key other than 
    SCAN.  Scanning stops.

(BR EB 1/10/00)