ITZA-2 Universal Remote Control (Purple)
(150-1999)                 Preparation                Faxback Doc. # 58222

Installing Batteries

Your remote control requires four AAA batteries (not supplied) for power.  
For the best performance and longest life, we recommend using RadioShack 
alkaline batteries.

CAUTIONS:  Use only fresh batteries of required size and recommended type.

           Do not mix old and new batteries or different types of
           batteries.

           Do not press any of the remote control's keys while installing
           batteries.

           Always remove old or weak batteries.  Batteries can leak
           chemicals that can destroy electronic parts.

           Dispose of old batteries promptly.  Do not burn or bury them.

Note: The ITZA-2's built-in memory backup saves any programmed codes for
      about 10 minutes after the batteries have been removed. We recommend
      you have fresh batteries ready to install as soon as you remove the
      old ones.

1.  Press the battery compartment cover and slide it off.

2.  Place the batteries in the compartment as indicated by the polarity
    symbols (+ and -) marked inside.

3.  Replace the cover.

When the ITZA-2's range decreases or it stops operating properly, promptly 
replace the batteries.

Note:  Do not place objects on top of the remote control after you have
       installed the batteries. This can press keys for an extended period
       of time and reduce the battery life.

Device Types

Use the remote control's device keys to control the following type of 
devices:

   TV key - TVs
  VCR key - VCRs and TV/VCR combinations.
  CBL key - Cable converters and satellite systems.
  AUX key - CD players, Video Accessories, and Home Automation Systems.

Setting Up Your Remote Control

1.  Refer to manufacturer Codes, in Faxback Doc. # 58218, and note the
    codes for your brand of device.

2.  Press the device key for the type of remote you are replacing (TV,
    VCR, CBL, or AUX).  The red light blinks.

3.  Hold down P until the red light blinks twice, then enter the 4-digit
    manufacturer's code.

    For example to replace a Panasonic TV's remote control (manufacturer's
    code 0051), press TV, hold down P until the red light blinks twice,
    then press 0-0-5-1.

    When the red light blinks twice, the code has been accepted.

    Note:  If the code you entered is invalid, the red light blinks.

4.  Point the remote control at your device and press POWER.  It should
    turn off (or on, if it was off).

    If the remote control does not operate your device, try the other
    codes listed in Manufacturer Codes for your brand of device.

5.  Repeat Steps 2 through 4 for additional devices.

To Operate Your TV/VCR Combination

1.  Locate the codes for your unit in TV/VCR Combination Codes and write
    them down for reference while setting up your remote control.

2.  Press VCR.  The red light blinks.

3.  Hold down P until the red light blinks twice, then enter the 4-digit
    manufacturer's code. When the red light blinks twice again, the remote
    control has accepted the code.

    Note:  If the code you entered is invalid, the red light blinks.

4.  Point the remote control at your TV/VCR combination and press POWER.
    Your device should turn off (or on, if it was off).

    If the remote does not operate your device, try the other codes you
    wrote down in Step 1.

    Note:  Some TV/VCR combinations require a second code to control
           volume.  If you cannot control the volume, use the TV code
           from "TV/VCR Combination Codes" in Faxback Doc. # 58218.

(EB 1/6/00)