ITZA-2 Universal Remote Control (Clear)
(150-1998)                 Operation                  Faxback Doc. # 58216

General Operation

1.  Press the device key for the device you want to control.

2.  Point the remote control toward the device you want to control, then
    press the desired command keys.

3.  Repeat Steps 1 and 2 for all other devices you want to operate.

    Note:  The command keys on the remote control work the same as the
           keys on the original remote control; however, the labeling
           might differ slightly.

4.  To turn off the last device you selected, press POWER.  To turn off
    other devices, press the device key for the device you want to turn
    off, then press POWER.

Converting Device Keys

You can use the ITZA-2 to operate a second TV or VCR (or other components) 
for a total of up to four devices.  To do this, you must first convert an 
unused device key (TV, VCR, CBL, or AUX) to operate each additional 
device.  For example, to convert AUX to operate a second TV:

1.  Hold down P until the red light blinks twice.

2.  Press 9 - 9 - 2.  The red light blinks twice.

3.  Press TV.

4.  Press AUX.  The red light blinks twice.

5.  Program the converted device key (AUX) with the code for the second
    TV.  (Also see "Setting Up Your Remote Control" in Faxback Doc. #
    58215.)

6.  Repeat steps 1 to 5 for each key you want to convert.  To convert a
    key back to its original function, repeat Steps 1 and 2, then press
    AUX twice.

Punch-Through

The punch-through feature lets you alternately control two different 
devices without pressing the device keys for each one.

A TV is often the only device that uses volume keys.  Punch-through allows 
you to control the TV's volume while the ITZA-2 is in any device mode. 
With punch-through on, press VCR and use ITZA-2's volume keys to control 
the TV's volume instead of the VCR's.

Turning Punch-Through OFF/ON

If your cable converter or VCR has volume control, you might want to turn 
off punch-through so you can use the cable converter's or VCR's volume 
instead of the TV's.

To turn off punch-through:

1.  Hold down P until the red light blinks twice.

2.  Press 9 - 9 - 3 then VOL +.  The red light blinks four times.

3.  When you want to control the volume through your cable converter,
    press CBL before using the volume control.

To turn punch-through back on:

1.  Hold down P until the red light blinks twice.

2.  Press 9 - 9 - 3, then the device key you want to control all volume
    (TV, for example). The red light blinks twice and the device you chose
    controls volume whenever you press a volume key on the ITZA-2.

Using the Strobing Light Feature

1.  Press the light key (lit light symbol).  The ITZA-2's light show will
    start and continue for about 15 seconds.  Now each time you press a
    key, the colorful strobing lights will appear.

    Note:  Continually pressing keys after the light show begins will
           cause the rate of blinking to slow down.

2.  To turn off the light feature, press the light key (lit light symbol)
    again.

(EB 1/5/00)