3-in-1 Simple Pocket Universal Remote Control
(15-1926)                 Preparation                Faxback Doc. # 52644

Installing Batteries

You need two AAA batteries to power your remote control.  We recommend 
alkaline batteries, available at your local RadioShack store.

CAUTIONS:  Use only fresh batteries of the required size and recommended
           type.

           Do not mix old and new batteries, different types of batteries
           (standard, alkaline, or rechargeable) or rechargeable batteries
           of different capacities.

           Do not press any of the 3-in-1's keys while installing
           batteries.

1.  Press the battery compartment cover's tab and lift off the cover.

2.  Install two AAA alkaline batteries as indicated by the polarity
    symbols (+ and -) marked inside the compartment.

3.  Replace the cover.

When the 3-in-1's range decreases or it stops operating properly, replace 
the batteries.

Notes:  Do not place objects on top of the remote control after you have
        installed the batteries.  This can reduce battery life.

        Although the 3-in-1 has a built-in memory backup, we recommend you
        have fresh batteries ready to install as soon as you remove the
        old ones.

Setting Up Your 3-In-1

1.  Refer to "Code List" in Faxback Doc. # 52647 and write down the codes
    for your original remote controls.

    Note:  To set up your 3-in-1 to control a TV/VCR combination, you must
           set and program both a TV code and a VCR code.

2.  Hold down SETUP until the 3-in-1's indicator lights.

    Note:  To exit setup at any time, press SETUP again.  The indicator
           flashes several times.

3.  Press the device key for the type of remote you are replacing (TV,
    VCR, CBL).  The indicator blinks once.

    Note:  If you do not press a device key within about 15 seconds, the
           indicator flashes for about 3 seconds.  Repeat Step 2.

4.  Enter the 3-digit code from "Code List" in Faxback Doc. # 52647,
    pressing REW, PAUSE, then FF the number of times which corresponds to
    the first, second, and third digit respectively.  The indicator lights
    with each keypress.

    For example, if the code is 013, press PAUSE once (first digit = 0,
    second digit = 1) and FF three times (third digit = 3).

    Note:  If the code you entered is invalid, the indicator flashes for
           about 3 seconds.

5.  Press MUTE to save the code.

6.  Point the 3-in-1 at your device and press POWER.  Your device should
    turn off (or on, if it was off).

    If the remote does not operate your device, try the other codes listed
    in "Code List" in Faxback Doc # 52647 for your brand of TV, VCR, cable
    converter, or other device.

7.  Repeat Steps 2-5 for additional devices.

(EB 5/12/99)