3-in-One Easy Remote Control
(15-1931)                 Operation                  Faxback Doc. # 48703

1.  Press the device key for the device you want to control, then point
    the remote control at the device and press PWR to turn the device on.

2.  Repeat Step 1 for all other devices you want to operate.

3.  Press the appropriate device key and the desired command keys.

    Note:  The command keys on the remote control work the same as the
           keys on the original remote control; however, the labeling
           might differ slightly.

4.  To turn off the last device you selected, press PWR.  To turn off
    other devices, press the device key for the device you want to turn
    off, then press PWR.

PUNCH-THROUGH

The punch-through feature lets you alternately control two different
devices without pressing the device keys for each one.  Here's how it
works.

Not all of the remote control's keys are used by every device.  For
example, a TV is often the only device that uses the volume keys.  After
you press TV, then press VCR, you can still use the volume control to
control the TV.

Note:  The punch-through feature might not work if the last two devices
       you selected have the same (or similar) features.  For example,
       most TVs and some cable converters have channel select keys on
       their remote controls.

Turning Punch-Through Off/On

If your cable box or VCR has a volume control, you might want to turn off
punch-through so you can use the cable box's or VCR's volume control to
control the sound.  To turn off punch-through, hold down P until the red
light blinks twice, then press 9 9 3 and the device key.

If you want to control the volume through your cable box, press CBL before
using the volume control.  If you want to control the volume through your
VCR, press VCR before using the volume control.

To turn punch-through back on, hold down P until the red light blinks
twice, then press 9 9 3 VOL /\.

FAVORITE CHANNEL SCAN

You can use your remote control to scan through up to 10 of your favorite
channels on your TV, VCR, or cable box.

Note:  You can scan channels only for one device (TV, VCR, or CBL) at a
       time.  You cannot set up a favorite channel list for another device
       until you clear the existing list.

1.  Press the device key for the device with the channels you want to
    program (TV, VCR, or CBL).  The red light blinks.

    Note:  If you do not press a device key within about 15 seconds, the
           red light turns off.  Start again from Step 1.

2.  Hold down P until the red light blinks twice, then press 9 9 6.

3.  Enter the channel number of the first channel you want to include in
    your favorite channel list.  Then press P.

    Notes:  Precede a single-digit number with a 0 - for example, 01, 02,
            and so on.

            If you enter a three-digit number, you do not need to press P
            after entering the number.

4.  Repeat Step 3 for other channels (up to 10) you want to include in
    your list.  Then hold down P until the red light blinks twice.

5.  To scan through the favorite channel list, press the device key for
    the device you want to tune (TV, VCR, or CBL), then press SCAN.  The
    remote control repeatedly scans through the favorite channel list,
    stopping on each channel for about 3 seconds.

6.  Press any key other than SCAN when you see a channel you want to
    watch.  Scanning stops.

Clearing Favorite Channel Scan

You must clear the channels in your favorite channel scan list if you want
to change them.

1.  Hold down P until the red light blinks twice.

2.  Press 9 9 6, then hold down P until the red light blinks twice.

(EB 7/8/98)