3-in-One Easy Remote Control
(15-1931)                 Preparation                Faxback Doc. # 48702

INSTALLING BATTERIES

Your remote control requires four AAA batteries (not supplied) for power.
For the best performance and longest life, we recommend alkaline batteries
such as RadioShack Cat. No. 23-555.

CAUTIONS:  Use only fresh batteries of the required size and recommended
           type.

           Do not mix old and new batteries or different types of
           batteries.

           Do not press any of the remote control's keys while installing
           batteries.

Note:  The remote control's built-in memory backup saves any programmed
       codes for about a minute after the batteries have been removed.  We
       recommend you have fresh batteries ready to install as soon as you
       remove the old ones.

1.  Press the battery compartment cover's tab and lift off the cover.

2.  Place the batteries in the compartment as indicated by the polarity
    symbols (+ and -) marked inside.

3.  Replace the cover.

When the remote control's range decreases or it stops operating properly,
replace the batteries.

CAUTIONS:  Always remove old or weak batteries.  Batteries can leak
           chemicals that can destroy electronic parts.

           Dispose of old batteries promptly and properly.  Do not burn or
           bury them.

Note:  Do not place objects on top of the remote control after you have
       installed the batteries.  This can press keys for an extended
       period of time and reduce battery life.

DEVICE TYPES

You can use the remote control's device keys to control the following
general types of devices:

  TV - TVs

  VCR - VCRs and TV/VCR combinations

  CBL - Cable converters

SETTING UP YOUR REMOTE CONTROL

1.  Refer to "Manufacturers' Codes" in Faxback Doc. # 48705 and write down
    the codes for your original remote controls on the supplied label.

    Notes:  Some manufacturers have several codes listed.  Try each until
            you find the right one.  See "If You Have Problems" in Faxback
            Doc. # 48704 if you cannot find the correct code.

            If you want to set up your remote control to control a
            combination TV/VCR (such as Cat. No. 16-421 or 16-422), you
            must program the TV code for the TV functions and the VCR code
            for the VCR functions.

2.  Press the device key for the type of remote you are replacing (TV,
    VCR, or CBL).  The red light blinks.

    Note:  If you do not press a device key within about 15 seconds, the
           red light turns off.  Start again from Step 2.

3.  Hold down P until the red light blinks twice, then enter the 3-digit
    code.

    For example, to replace a TV's remote control (manufacturer's code
    185), press TV, hold down P until the red light blinks twice, then
    press 1, 8, and 5.

    When the red light blinks twice, the remote control has accepted the
    code.

    Note:  If the code you entered is invalid, the red light does not
           blink.

4.  Point the remote control at your device and press PWR.  Your device
    should turn off (or on, if it was off).

    If the remote does not operate you device, try the other codes listed
    in "Manufacturers' Codes" in Faxback Doc. # 48705 for your brand of
    TV, VCR, cable converter, or other device.

5.  Repeat Steps 2-4 for additional devices.

(EB 7/8/98)