7-In-1 Remote Control with Lighted
Keypad (15-1924)          Troubleshooting            Faxback Doc. # 46324

IF YOU HAVE PROBLEMS

Manual Code Search

If the 7-in-1 Remote Control does not operate your remote-controlled
devices when you first set it up, you might have to manually find the
correct code for your devices.  You can try all the codes listed in
'Manufacturer's Codes' for the brand of your devices, or you can follow
these steps to search the 7-in-1's entire library.

1.  Manually turn on the device you want to set up.

2.  Hold down [SET UP] on the 7-in-1 until the red light above 'lightbulb'
    turns on.

3.  Press the corresponding device key on your 7-in-1 Remote Control (TV,
    VCR, CBL, CD, and so on).  Or, to search all the codes available to
    AUX1 or AUX2 to control a device, press AUX1 or AUX2 then the
    corresponding device key.  The red light blinks once.

4.  Aim the 7-in-1 Remote Control at the device you want to operate.

5.  Repeatedly press [ON] (Channel + [ON], Play, or Power (All Lts On)
    until the device responds to the command.

6.  When the device responds to the command, press [ENT] within 5 seconds
    to save the code.

NOTES:  If you accidentally overshoot the correct code, repeatedly press
        [LAST] then [ON] (Channel + [ON], Play or Power (All Lts On) on
        the 7-in-1 to move back through the codes until the device
        responds to the command.

        If you do not press [ENT] within 5 seconds, the 7-in-1 does not
        save the code.

        Because the 7-in-1's library has so many codes, this procedure can
        take several minutes.

        If your device turns off during the search, but does not operate
        after you lock in the code, begin the search again, pausing longer
        between key presses.

If necessary, repeat these steps for each device.

Determining the 3-Digit Code

After you set up your 7-in-1 Remote Control using manual code search, you
can find which 3-digit code the 7-in-1 Remote Control is set to by
following these steps.

1.  Hold down [SET UP] until the red light above 'lightbulb' turns on.

2.  Press the device key you want to get the manufacturer's code from.
    The red light blinks once then stays on.

3.  Press [SET UP].  The red light blinks once then stays on.

4.  Press [0] [1] [2][3] [4] [5] [6] [7] [8] [9] [0], waiting a few
    seconds after your press each number before you press the next one.

    If the red light blinks after you press a number, that number is the
    first number of your 3-digit manufacturer's code.

5.  Repeat Step 4 twice to find the second and third numbers of your 3-
    digit manufacturer's code.  After the red light blinks for the third
    digit in the code, it turns off.

(wr 07/29/98)