3-IN-1 Easy Remote Control
(15-1916B)                Preparation                Faxback Doc. # 44688

Installing Batteries

CAUTIONS:  Be sure to have fresh batteries ready to install before you
           remove the old batteries.  The 3 in 1's memory only lasts about
           a minute without the batteries.  If the memory is lost, simply
           re-enter the 3-digit manufacturers' codes for your remote-
           controlled devices.

           Do not mix old and new batteries, different types of batteries
           (standard, alkaline, or rechargeable), or rechargeable batteries
           of different capacities.

1.  Press the battery compartment cover tab and lift off the cover.

2.  Install two AAA alkaline batteries as indicated by the polarity symbols
    marked inside the compartment.

3.  Replace the cover.

When the 3 in 1's range decreases or the 3 in 1 operates erratically,
replace the batteries.

NOTE:  Do not place objects on top of the remote control after you install
       the batteries.  This can press down keys and reduce battery life.

Setting Up Your Remote Control

1.  Refer to "Manufacturers' Codes" on Faxback Doc. # 16722 and write down
    the codes for your original remote controls on the provided label.

2.  Press the device key for the type of remote you are replacing (TV, VCR,
    or CBL).

3.  Hold down P until the red indicator blinks twice, then release P and
    enter the 3-digit manufacturer's code.

    For example, to replace a Panasonic TV's remote control (manufacturer
    code 051), you would press:

        TV P 0 5 1

4.  When the indicator blinks twice again, point the 3 in 1 at your device
    and press PWR.  The device should turn on (or off, if it was on).

Repeat these steps for additional devices.

NOTES:  The punch-through feature is automatically turned on for the TV's
        volume and mute controls.  This means that when you select CBL and
        press one of the volume buttons or MUTE, the remote actually sends
        the codes to the television to control it, not the cable converter.
        If you want to use your cable converter's volume and mute controls,
        disable the punch-through feature for these buttons.  See "Punch
        Through" on Faxback Doc. # 44689.

        If the remote does not operate your device, try other codes listed
        in "Manufacturers' Codes" for your brand of TV, VCR, or cable box.
        If your device still does not respond, follow the steps outlined in
        "If You Have Problems" on Faxback Doc. # 44690.


(br/EB 10/13/97)