Universal Remote Control
(15-1901A)                Battery Installation       Faxback Doc. # 41168


The URC is powered by four AA batteries.  Use only alkaline batteries
(Radio Shack Cat. No. 23-552).  The URC requires the extra power of
alkalines and might not perform properly with standard or rechargeable
batteries.

1.  Remove the battery compartment cover by pressing it in the direction
    of the arrow.

2.  Install four new AA batteries, observing the polarity (+ and -)
    marked in the compartment.

3.  Using a pen or pencil, press [RESET] inside the battery compartment.

    NOTE:  Press [RESET] only when you are installing batteries for the
           first time or if the microprocessor locks up.  See 
           "Troubleshooting," Faxback Doc. # 41170.

4.  Replace the compartment cover.

    NOTES:  A set of batteries provides power for up to six months of
            normal use.  However, to avoid loss of the learned commands
            and command sequences, replace the batteries as soon as you
            see the BAT LO indicator on the display.

            If you use the URC after the BAT LO indicator lights, BATTERY
            flashes or lights steadily on the display.  When BATTERY
            appears, immediately replace the batteries to avoid loss of
            the URC's memory information.

            The URC holds learned commands and command sequences in memory
            for 5 minutes without batteries.  Be sure you have new
            batteries ready to install before you remove the old
            batteries.

            You must reset the clock and the timers each time you replace
            the batteries.

            Never leave weak batteries in the URC.  They can leak damaging
            chemicals.

            Do not mix old and new batteries.

(LB/km-08/20/1997)