6 in 1 RF Remote Control System
(15-1919)                  Preparation                Faxback Doc. # 35712


SETTING UP THE 6 IN 1 RF REMOTE CONTROL SYSTEM'S REMOTE CONTROL

INSTALLING BATTERIES

1.  Press the battery compartment cover tab and lift off the cover.

2.  Install four fresh AAA alkaline batteries (Radio Shack Cat. No. 23-555)
    as indicated by the polarity symbols marked in the battery compartment.

3.  Replace the cover.

NOTE:  Do not place objects on top of the remote control after you install
       the batteries.  This can press keys and reduce battery life.

When the 6 in 1 RF Remote Control System's remote control's range decreases
or operates erratically, replace the batteries.

CAUTION: Be sure to have fresh batteries ready to install before you remove
         the old batteries.  The remote control's memory only lasts about a
         minute without the batteries.  If the memory is lost, simply re-
         enter the 3-digit manufacturers' code for your remote controlled
         devices.

1.  Refer to "Manufacturers' Codes" and write down the code for your
    original remote controls on the provided label.

2.  Press the device key for the remote you are replacing (CD, VCR, CBL, TV,
    AUX1, or AUX2).

3.  Press down and hold Set Up until the red indicator blinks twice then
    release it.  Then enter the 3-digit manufacturer code.

Repeat steps 2-5 for additional devices.

If the remote does not operate your device, try other codes listed in "Man-ufacturers' Codes" for your brand of TV, VCR, cable converter, or other
devices.

For example: To replace a Panasonic TVs remote control (manufacturer code
051), you would press: TV - Set Up - 0 - 5 - 1

4.  When the indicator blinks twice again you have correctly entered the
    code.

5.  Point the 6 in 1 RF Remote control System's remote at your device and
    press PWR.  The device should turn on (or off, if it was on).

    If your device still does not respond, follow the steps outlined in "If
    You Have Problems."

NOTES: The Punch-Through feature is automatically turned on for the TV's
       volume and mute controls.  This means that when you select cable and
       press one of the volume buttons or the mute button, the remote
       actually sends the codes to the television and not the cable conver-
       ter.  If you want to use your cable converter's volume and mute con-
       trols, disable the Punch-Through feature for these buttons.  See
       "Punch - Through."

       When your remote control's range decreases or the 6 in 1 RF Remote
       Control System operates erratically, replace the batteries in the
       remote control.


(BR/EB 11/12/96)