Three-In-One Easy  (15-1916)      Preparation         Faxback Doc. # 16720
Remote

HOW THE REMOTE WORKS

Before you begin to use the 3-in-1, it is helpful to understand a little
about how it works - nothing technical - only an idea of what you can
expect from the 3-in-1.

After you set up the 3-in-1, its command keys work like the keys on your
original remote controls, though the labeling might differ slightly.  For
example, a key on your original remote control labeled PWR ON/OFF is
equivalent to the 3-in-1's PWR key.

NOTES:  P is a special key that you use when you set up (program) the
        3-in-1 to replace your original remote controls.

        TV, VCR, and CBL are device keys.  You use them when you set up the
        3-in-1 to replace your original remote controls.  You also use the
        device keys during normal operation to tell the 3-in-1 which device
        you want to control.

        PWR (power), MUTE, and LAST (recall) operate the same as on your
        original remote control.

        Whenever you use the 3-in-1's RECORD key, you must press it twice.
        This safety feature helps prevent you from accidentally erasing
        video tapes.

SETTING UP THE 3-IN-1

INSTALLING BATTERIES

CAUTION:  Be sure to have fresh batteries ready to install before you
          remove the old batteries.  The 3-in-1's memory only lasts about
          a minute without the batteries.  If the memory is lost, simply
          re-enter the 3-digit manufacturers' codes for your remote
          controlled devices.

1.  Press the battery compartment cover tab and lift off the cover.

2.  Install two fresh AAA alkaline batteries (Radio Shack Cat. No. 23-555)
    as indicated by the illustration in the battery compartment.

3.  Replace the cover.

When the 3-in-1's range decreases or the 3-in-1 operates erratically,
replace the batteries.

NOTE:  Do not place objects on top of the remote control after you install
       the batteries.  This can press down keys and reduce battery life.

SETTING UP YOUR REMOTE CONTROL

1.  Refer to "Manufacturers' Codes" and write down the codes for your
    original remote controls on the provided label.

2.  Press the device key for the type of remote you are replacing (TV, VCR,
    or CBL).

3.  Press down and hold P until the red indicator blinks twice, and
    continue holding it down as you enter the 3-digit manufacturer's code.

    For example, to replace a Panasonic TV's remote control (manufacturer
    code 051), press:

                  TV - P - O - 5 - 1

    NOTE:  The red indicator at the top of the 3-in-1 flashes twice when
           you enter a code that it recognizes.  (This does not mean that 
           it is the right code for your device.)

4.  Release P.

5.  Point the 3-in-1 at your device and press PWR.  The device should turn
    on (or off, if it was on).

Repeat these steps for additional devices.

NOTES:  The punch-through feature is automatically turned on for the TV's
        volume and mute controls.  This means that when you select CBL and
        press one of the volume buttons or MUTE, the remote actually sends
        the codes to the television to control it, not the cable converter.
        If you want to use your cable converter's VOLUME and MUTE controls,
        disable the punch-through feature for these buttons.  See "Punch
        Through."

        If the remote does not operate your device, try other codes listed
        in "Manufacturers' Codes" for your brand of TV, VCR, or cable box.

        If your device still does not respond, follow the steps outlined
        in "If You Have Problems."


(/all-08/28/95)