MENU     Set Up     Re-Assigning Device Keys

How to Program your One For All® remote

(Model URC-3030)

Set Up

To set up the remote for your Device(TV,VCR,CABLE).
  • Turn on the device (TV or VCR,CABLE) that you want to operate.
  • Press the device button and release.
  • Press and HOLD SETUP-- after about three seconds, the red light will blink twice-release SETUP.
  • Enter the four digit code you found for your device. If you put the code in correctly, the light on the remote will blink twice.
    Remember: VOL UP = 1, VOL DOWN= 2, CH UP = 3, CH DOWN = 4
  • Aim the One For All® 3 at your device and press POWER. The device should turn off.
  • If your device does not turn off, repeat steps 2-4, trying each code listed for the brand of your device. Device Set-Up Codes
NOTE: Some VCR's did not have a POWER key on the original remote. Try putting a tape in your VCR and using the PLAY key to test the codes.

menu

Re-Assigning Device Keys

You can use the One For All® 3 to operate a second TV,VCR, or CABLE box. To do so, you must re-assign one of the device keys (TV ,VCR,or CABLE) to operate your second unit. The examples below shows you how to re-assign the device keys.

TV to VCR

  • Press Setup (hold 2 blinks)
  • Tap CH-, CH-, VOL +
  • Tap VCR and then TV
  • Set up VCR on the TV key using the "Set Up" instructions (above)

VCR to TV

  • Press Setup (hold 2 blinks)
  • Tap CH-, CH-, VOL +
  • Tap TV and then VCR
  • Set up TV on the VCR key using the "Set Up" instructions (above)

CABLE to TV

  • Press Setup (hold 2 blinks)
  • Tap CH-, CH-, VOL+
  • Tap TV and then CABLE
  • Set up TV on the CABLE key using the "Set Up" instructons (above)

Any of the device buttons can be set to work any device this way.

menu


All Material Copyright Universal Electronics Inc.
"One For All" copyright Universal Electronics Inc.
Any questions about the products should be directed to help@ueic.com