View previous topic :: View next topic |
Author |
Message |
terschen
Joined: 21 Sep 2003 Posts: 10
|
Posted: Sun Feb 03, 2008 11:07 am Post subject: KM "ERROR" text in HEX column |
|
|
In KM with Pioneer 3DEV, I get the text "ERROR" in the HEX column after I enter some of the byte2 values in the functions sheet. I am using the setup of 165/164/blank in the device 1/2/3, and it seems that any byte2 for OBC's higher than 031 generates the ERROR text when I user a low value as the first OBC. For example, OBC 090 and byte2 1 203 generates the ERROR text in the HEX column, but combinations like 094 and 1 008 work fine, as do 159 and 1 212. I learned the combinations in IR, and verified they were learned correctly and are double device 165 combinations. Other single 165 and 164 commands or double 165 and 165/164 commands work fine. The ones I am having trouble with are 092 1 192, 090 1 202, 091 1 192, 090 1 203 and 090 1 203. Any ideas? |
|
Back to top |
|
|
mr_d_p_gumby Expert
Joined: 03 Aug 2003 Posts: 1370 Location: Newbury Park, CA |
Posted: Mon Feb 04, 2008 3:23 pm Post subject: |
|
|
This is not a limitation of KM (or RM), but rather a limitation of the Pioneer 3DEV executor. Refer to this post for further explanation. _________________ Mike England |
|
Back to top |
|
|
terschen
Joined: 21 Sep 2003 Posts: 10
|
Posted: Mon Feb 04, 2008 10:26 pm Post subject: |
|
|
Thanks Mike! I searched quite a bit but didn't find that post. I'll use one of the two methods noted in the post link. Thanks again Mike.
Terry |
|
Back to top |
|
|
|