G'day folks. I have a problem with a JP1 cable I made myself. I am using a URC-7550 remote.
When I connect the cable nothing happens. I have been through all the instructions I can find including this one http://www.hifi-remote.com/jp1/simple/index.shtml#test
and the one put out by Tommy Tyler.
As far as I can tell all is working properly as far as the cable goes. Have checked in the BIOS to make sure the Parallel is set to go. SO after that I am pretty much out of ideas.
I have a small multimeter if that is of any help to get this thing going so all suggestions gratefully received and acted upon.
Have also tried out different battery combinations including turned around flat full and half way in between and none at all.
JP1 Cable Problems
Moderator: Moderators
OK Still playing with it
Still playing with it but not a lot of success so far.
After I have plugged it into the parallel port and open up IR.exe I go to Interface/check Interface.
It tells me no response from the remote Make sure your interface is plugged into JP1 properly.
As it does this the light on the remote flashes twice.
And that is as far as it goes
The remote is a URC-7550
Any idea where I am going wrong?
Edited for this question
As an aside does it matter which way the resistors hook up? Haven't been able to find anything that tells me what way they go. The Diode is the right way according to the instructions I have found but nothing about resistors. Electronic newbie here.
Thanks again
After I have plugged it into the parallel port and open up IR.exe I go to Interface/check Interface.
It tells me no response from the remote Make sure your interface is plugged into JP1 properly.
As it does this the light on the remote flashes twice.
And that is as far as it goes
The remote is a URC-7550
Any idea where I am going wrong?
Edited for this question
As an aside does it matter which way the resistors hook up? Haven't been able to find anything that tells me what way they go. The Diode is the right way according to the instructions I have found but nothing about resistors. Electronic newbie here.
Thanks again
Yep
I used 1k 1/4 watt resistors. I have used a multimeter to check and wires are all good going to where they are supposed to as far as I can tell. Should I be able to get a reading on the other side of the resistors and the Diode? If so what setting on the Multimeter should I be using and does it need power of some sort to get the reading.
Have only used for power in cars so far so explain carefully please.
Thanks again
Have only used for power in cars so far so explain carefully please.
Thanks again
Woohoo sort off
All sorted now. Bright spark me couldn't tell the difference between a Diode & a Resistor so had 2 Diodes and 1 resistor.
Really should have names on them
)
Really should have names on them
)