Before I get more frustrated trying to get this to work. Which cable should I be using for a JP 1.1 remote? I purchased a "Simple JP1 cable" from DIY and it only has 4 wires (nothing on pins 1&2). I've tried sending them e-mails twice, but get no response.
- Remote = Cox Cable M7820 (UEI) JP 1.1 port
- I've tried IR505 & JP112 (on my C drive)
- Printer port is enabled, with No Interupts set
- No printer set up for printer port use and I am the Admin account
- Driver Status shows the parallel/serial driver present
- I've also tried the "reverse the battery" trick to no avail...
Results:
- No response from the remote. Make sure your Interface is plugged into JP1 correctly.
I'm running out of ideas... I keep reading through the newbie section trying to find what I may have missed, but come back with nothing new to try.
Help, please!
JP 1.1 - which cable?
Moderator: Moderators
-
The Robman
- Site Owner
- Posts: 21889
- Joined: Fri Aug 01, 2003 9:37 am
- Location: Chicago, IL
- Contact:
The "Simple" cable is not for JP1.1 remotes, so don't waste anymore time trying to get your cable remote working with it.
You'll need a JP1.x cable for this remote. "JP1.x" cables are designed to work with both JP1.1 and JP1.2 remotes. Cables sold as "JP1.2" will not work with JP1.1 without further modification.
You'll need a JP1.x cable for this remote. "JP1.x" cables are designed to work with both JP1.1 and JP1.2 remotes. Cables sold as "JP1.2" will not work with JP1.1 without further modification.
Rob
www.hifi-remote.com
Please don't PM me with remote questions, post them in the forums so all the experts can help!
www.hifi-remote.com
Please don't PM me with remote questions, post them in the forums so all the experts can help!