Page 1 of 1
Which Protocol for Yamaha rx-v1000
Posted: Tue Aug 22, 2006 6:18 pm
by EZ Ed
I have an old 6131 2k and am using the extender. I have a problem with all extended codes which have a device number 124 or 126, device 122 codes are fine. I using protocol Nec1 id 00 5A. I tried the NEC Combo protocol but then nothing worked. Which protocol should I use?
Posted: Tue Aug 22, 2006 8:02 pm
by The Robman
You need to use the "Device Combiner" as we don't have a combo protocol that lets you mix the main NEC device codes.
Posted: Wed Aug 23, 2006 12:34 pm
by mr_d_p_gumby
IIUC, you need three main devices (122, 124 126). You might try the NEC 4DEV combo that has just been added to KM v9.04. It allows you to mix 4 NEC device codes.
Posted: Wed Aug 23, 2006 6:42 pm
by EZ Ed
mr_d_p_gumby wrote:IIUC, you need three main devices (122, 124 126). You might try the NEC 4DEV combo that has just been added to KM v9.04. It allows you to mix 4 NEC device codes.
I tried NEC 4DEV and still no success, I'll keep trying.
Thanks for your help Ed
Posted: Wed Aug 23, 2006 9:34 pm
by EZ Ed
I think I see my error I didn't fill in the byte2 pair NEC column on the Functions tab.
Posted: Wed Aug 23, 2006 9:49 pm
by The Robman
If you want us to check your work at any point, you should upload your KM file for us to look at.
Posted: Thu Aug 24, 2006 4:32 pm
by EZ Ed
The Robman wrote:If you want us to check your work at any point, you should upload your KM file for us to look at.
Thanks Rob it's finally working for other devices the addition of values to the function tab did the trick. I appreciate all the work you and the other developers do.
Ed