View previous topic :: View next topic |
Author |
Message |
gaines
Joined: 01 Jul 2006 Posts: 12 Location: Nashville, TN |
Posted: Thu Jul 13, 2006 8:38 pm Post subject: Sporadic Success Learning Codes |
|
|
I'm trying to build my first upgrade for my URC-9910 using the learning function, but it seems to work fine sometimes and other times it seems to have trouble figuring out what the code should be.
For instance, below are a couple of examples when I was learning the channel up/down buttons on my Sony VCR remote. The top part of the screen shot is when it learned it incorrectly. The bottom part is when it seemed to do it correctly.
Could this just be a matter of how long I hold the button and how close I put the remotes to each other when I'm learning the code, or is there something else going on here?
{screen shots deleted - Rob} |
|
Back to top |
|
|
gfb107 Expert
Joined: 03 Aug 2003 Posts: 3411 Location: Cary, NC |
|
Back to top |
|
|
gaines
Joined: 01 Jul 2006 Posts: 12 Location: Nashville, TN |
Posted: Thu Jul 13, 2006 9:27 pm Post subject: |
|
|
The 9910 is a LCD display remote so those instructions don't apply, but I am following the instructions for this model remote.
Unfortunately I didn't dump the raw data for those remote downloads. I will upload some dumps as I continue trying to learn codes. |
|
Back to top |
|
|
gaines
Joined: 01 Jul 2006 Posts: 12 Location: Nashville, TN |
|
Back to top |
|
|
gfb107 Expert
Joined: 03 Aug 2003 Posts: 3411 Location: Cary, NC |
|
Back to top |
|
|
gaines
Joined: 01 Jul 2006 Posts: 12 Location: Nashville, TN |
|
Back to top |
|
|
johnsfine Site Admin
Joined: 10 Aug 2003 Posts: 4766 Location: Bedford, MA |
Posted: Fri Jul 14, 2006 5:00 am Post subject: |
|
|
Did you try relearning it?
I manually decoded that bad learn on TV:UP. It has an OBC number of 19.
Since I gave you the OBC, you don't need to relearn, but for future reference, that kind of mislearn is typically caused by moving the remotes while learning. Both remotes should be on a firm surface for learning. Don't try to learn holding the remotes in your hands. |
|
Back to top |
|
|
johnsfine Site Admin
Joined: 10 Aug 2003 Posts: 4766 Location: Bedford, MA |
Posted: Fri Jul 14, 2006 5:11 am Post subject: |
|
|
The bad learns from that file are:
VCR:Power Looks like the batteries in the source remote weren't good enough to learn from, but I'm not at all sure. Try again with better batteries.
TV:Stop Also looks like the batteries in the source remote. There might be enough there for a hand decode (haven't tried yet) but relearning should be easier.
TV:Menu The Sony12 decode is correct. Ignore the rest.
TV:Pause More battery problems.
TV:Prev You sure have a strange mix of learns here. Are these from multiple original devices? It's easier to figure these things out if you know which learns are from the same device.
TV:3 Looks like battery problems again. |
|
Back to top |
|
|
|