Page 1 of 1
JP1 Help URC 6960
Posted: Sun Nov 27, 2005 12:40 pm
by anand
I have a URC 6960 Kameleon remote and need to program some keys into it. I ordered a JP1 cable but it does not fit. The cable has 6 pins, the remote has 6 solder heads. Can anyone help with what I need.
I tried to hold the pins to the solder heads and used IR to read the remote, but no luck
Please Advise
Anand
Posted: Sun Nov 27, 2005 12:58 pm
by The Robman
With any Kameleon remote, you need to also buy the pogo-pin adapter.
Posted: Sun Nov 27, 2005 1:10 pm
by anand
With any Kameleon remote, you need to also buy the pogo-pin adapter
Don't mean to be cheeky, the following website is where I get my components from, could you please tell me what the part(s) is that I need.
www.rswww.com
Thank you
Anand
Posted: Sun Nov 27, 2005 2:15 pm
by Capn Trips
HovisDirect is the one vendor who lists in the
MARKETPLACE section of this forum who offers a pogo adapter. I don't know that this is a piece any wholesaler would have. You either make one or buy one from Hovis.
P.S. Your link doesn't work, I believe since you have a space before the [
Posted: Sun Nov 27, 2005 2:47 pm
by Mark Pierson
Capn Trips wrote:Your link doesn't work
Fixed link.
Posted: Sun Nov 27, 2005 3:10 pm
by The Robman
anand wrote:Don't mean to be cheeky, the following website is where I get my components from, could you please tell me what the part(s) is that I need.
Just like a JP1 cable, the pogo-pin adapter is a JP1 part, it's not something that you can buy from a regular shop. So, you either need to make one yourself or buy one from the same person that you bought your JP1 cable from.