request code for Epson Projector EMP 800

[cavourahpong]

Dear all,

I am using One For All Remote (URC9960 B01).
I have tried to learnt the IR remote of Epson Projector EMP-800.

The process on learning looks success. But when I used the IR.exe to read my learnt. I found some problems happened in the "Learned Signals" sheet:
1. No data in the area of (Protocol, Device, Sub-Device, OBC, Hex Cmd, EFC, Misc)
2. Frequency = 36866
3. With Data in the area of "Sent Once When Key Is Pressed:"
4. No Data in the area of "Sent Once Upon Completion Of Other Bursts:"
Remark:
In this page, I can see what keys I have learnt;
The "Learned" memory bar shown some of memory is used to stored these learnt keys.

I want to know what happen?

And who have the code for Epson Projector EMP 800? If yes, please give me.

Regards,
Cavour

[Capn Trips]

You are asking two questions, here.

(1) First you desire assistance decoding your learned signals. The best way to get this help is to upload your file in the "diagnosis area" of the "file section" (see the link near the top of this page). Then provide a link to your file in a message posted here. Someone will have a look and try to help you.

(2) Your second question is a request for the codes for an Epson projector. That would normally be a separate request in the "Code Search" forum, rather than the "Beginners" forum. There is a "sticky post" there that explains the procedure to ask for code search assistance.

(Plus there is an upgrade for Epson projectors in the file section.