JP1 Remotes

Posted: **Sun Nov 16, 2003 8:03 am**

Somewhere I saw a post (and cannot find it now) where there was a way to modify the RDF file so a description could be put in for the device protocol code so in keymoves and general you might see "Sony TiVo" vs. 2001.

Am I making this up??? I have searched on the JPI and yahoo forums to no avail...

Thanks ahead...

greg

Posted: **Sun Nov 16, 2003 8:19 am**

It's been discussed as something that would be nice to have, but AFAIK it can't currently be done.

Posted: **Sun Nov 16, 2003 9:14 am**

Under the "[DeviceButtons]" section of the appropriate RDF file, I usually
change the db-0x to match the special protocols that are bound to them
like db-dsm, db-ldkp, etc., so I can remember them easier than
misc/1103 and misc/1106.

In my experience, in the same section, you can rename TV to SonyTV
and IR would display SonyTV in the UI. I don't know if that is answering
what you are asking.

JP1 Remotes

Commenting in IR.exe

Commenting in IR.exe