Hauppauge DEC-2000t - RC-5 toggle issue

migmog · Post by **migmog** » Sat Jun 25, 2005 8:05 am

Hi - I've spent a few hours with a JP1 cable trying to get my dec-2000t remote going, here's the issue...

It's RC-5, but the original remote appears to be alternating between codes (T=0/T=1) every time you press a button. I can't seem to get the OFA remote to do this.

Any ideas?

thanks
Andrew

1. Device: Hauppauge DEC 2000-t
2. Type of device: DVB (Freeview) STB
3. JP1 Remote model: URC-7550
4. JP1 user? Yes
5. Still have original remote? Yes
6. Checked the file section? Yes
7. Checked Pronto file section (at R/C)? No
8. Partially working setup code? Yes
9. Learning remote question? Yes

gfb107 · Post by **gfb107** » Sat Jun 25, 2005 8:14 am

What is the partially working setup code you are using?
How are you trying to control the device? Are you using the learned signals, building a device upgrade, or using keymoves?

Post your IR file and device upgrades in the diagnosis area and someone can take a look.

migmog · Post by **migmog** » Sat Jun 25, 2005 8:49 am

> What is the partially working setup code you are using?

I went to Yahoo, and found SAT-1294 for Hauppauge, which did absolutely nothing right. I've overridden all the buttons with learned signals.

> How are you trying to control the device? Are you using the learned signals, building a device upgrade, or using keymoves?

Learned signals.

> Post your IR file and device upgrades in the diagnosis area and someone can take a look.

I'll try to do this. - I take it there's not a simple way to get the remote to use the toggle bit? I'm assuming that's all that I need to get it to do.[/quote]

gfb107 · Post by **gfb107** » Sat Jun 25, 2005 9:53 am

Learned signals can't be used to control devices that use toggle bits. A device upgrade could do it.

WHen you say

SAT-1294 for Hauppauge, which did absolutely nothing right

what do you mean?

Does the device not respond at all, or are the functions just on the wrong buttons?

If it's just a case of having the wrong functions on buttons, you probably forgot to switch the remote in KM/RM before installing the upgrade into your remote. Otherwise, build your own upgrade using the signals you've learned.
You can learn how to do that in JP1 - Just How Easy Is It?, or JP1 - Just How Easy Is It? for RM Users.

migmog · Post by **migmog** » Sat Jun 25, 2005 5:54 pm

Thanks for the pointers, I got it working by creating an upgrade.

Andrew

Post by **The Robman** » Sat Jun 25, 2005 8:01 pm

If your upgrade is different to the one in the file section, be sure to load your version into the file section so others can use it.