Page 1 of 1
RS 15-2117 Multiple Emitters?
Posted: Fri Nov 05, 2004 2:37 pm
by Toys4Boys
On the RF receiver unit is a connection for an IR blaster but I'm wondering if someone can advise me as to how to connect multiple emitters w/out blowing them.
Thanks,
Mark
Posted: Fri Nov 05, 2004 3:02 pm
by The Robman
Use a "Y" adapter or buy a dual emitter IR blaster.
Posted: Fri Dec 30, 2005 5:15 am
by m.mckernan
Digging up an old post here but it's on the topic of what I am looking for....
Rob - is there a recomended type of emitter for the 2117 base station? I have read the socket on the back of the base station is smaller than most standard ir emitters. I am looking for a way to get three emitters running off the 2117 base station. Any suggestions?
Posted: Fri Jan 06, 2006 2:14 pm
by krbuck
I'm in a similar situation, but will be controlling four devices in a wiring closet. I assume the best thing to do is to arrange the blasters to cover multiple equipment IR receivers.
Hopefully, the number of blasters you can attach isn't too small.
Posted: Sat Jan 14, 2006 12:45 am
by crust
Internally, the external emitter is wired in parallel with one of the IR leds in the unit (or that is what I recall from a project I built with it). In any case, the connector is a 2.5mm mono connector. RS sells them for a couple of bones in a package of 2.
Posted: Sat Mar 25, 2006 5:49 pm
by katiebear00
Has anyone every found a comercially available IR blaster that works with the 2117? I tried wiring in two more emitters in paralell, and it didnt work. After spending many hours on this, I'm thinking of just buying a whole new extender.