15-2117 Mem Fault and Bad E2 Error

slotman6 · Post by **slotman6** » Wed Oct 13, 2004 10:59 pm

I just got a new 15-2117 and when i try to program it in the learning mode i get a mem fault error if i try to reset it to factory settings i get a bad e2 error. does anyone know how to fix this problem.

Thanks

Post by **The Robman** » Thu Oct 14, 2004 6:29 am

First please confirm that you're doing a true factory reset, like this...

1) Hold SETUP (green P), wait for screen to change
2) Tap RECORD
3) Follow prompts

If you did this and still get the BAD E2 message, you have a faulty remote. Someone in Canada recently had the same thing happen with several URC-9911 remotes that they bought from Futureshop.

However, they just returned the remotes so we don't know what the real problem was. Plus, seeing as how your local RS probably doesn't have any more 15-2117s available, your best option is to try and fix it. I would start by checking that the EEPROM is soldered in properly.

slotman6 · Post by **slotman6** » Thu Oct 14, 2004 10:55 am

Thanks that did it

Post by **The Robman** » Thu Oct 14, 2004 11:32 am

So, you were doing an OPS RESET rather than an MFR RESET ?

robertmyhtpc · Post by **robertmyhtpc** » Mon Dec 12, 2005 7:25 am

Robman

I have the same symptoms mentioned here, but on OforA 8910's. I get memory fault after uploading a known good file. I have tried ops reset, but hoping there is the same Manufacturers Reset you mentioned for the Radio Shack remote.

Thanks

Post by **The Robman** » Mon Dec 12, 2005 7:40 am

robertmyhtpc wrote:I have tried ops reset, but hoping there is the same Manufacturers Reset you mentioned for the Radio Shack remote.

Yes there is.

JP1 Remotes